The machine of the type WSM 101 (semi automatic) and WSM 102 (automatic)
was engineered for cutting timing and flat belt sleeves. It is especially
suitable for processing frequently changing sleeves and profile types with
medium to high quantities.
All common timing belt profile types can be processed.
 |
Max. belt length 5.800 mm |
|
|
Min. belt length 130 mm (with device for cutting small belts) |
|
|
Max. belt width 750 mm |
|
|
Stable, welded construction |
|
|
Delivered as one unit |
|
|
Affixing of the frame to the floor possible |
|
|
All linear ducts are made of hardened,
grinded steel shafts and ball bearings |
|
|
Tension of the sleeve is variable min. 3 kp max. 140 kp |
|
|
Moving of tension slide by drive motor |
|
|
Angle of tension shaft variable |
|
|
Semi-automatic processing WSM 101, controlled by PLC |
|
|
Automatic processing WSM 102, controlled by PLC |
|
|
Cutting die movement via ball screw driven by drive motor |
|
|
Digital display of die position, cutting with and number of cuts |
|
|
Cutting tool is a fixed round die |
|
|
Tool holder exchangeable |
|
|
Execution of cutting motion by lever (WSM 101) |
|
|
Execution of the cutting motion automatically (WSM 102) |
|
|
Stepless rpm-control via frequency converter from 70 to 450 rpm |
|
|
Rotation direction changable |
|
|
Plastic sheath as wearout-cover, Ø 70 mm |
|
|
Pneumatically triggered holder for supporting the cutting shaft |
|
|
Tool for exchanging the cutting shaft |
|
|
Tool for exchanging the cutting die |
|
|
Key for the wiring cabinet |
|
|
Wiring diagram |
|
|
Manual |
|
|
Emergency power off |
|
|
Safety knife cover |
|
|
Tension is limited when using device for cutting small belts |
|
|
Release of the tension only with closed holder of the cutting shaft |
|
|
Overload protection of all drive motors |
|
|
Device for cutting small belts (min 130 mm in length, up to 450 mm belt width) |
|
|
Semi-automatic control for the angle of the cutting shaft |
|
|
Push-on shaft in addition to cutting shaft |
|
|
Special die unit for cutting poly-v-rip belts |
|
|
Cutting shaft in special diameters (40 mm, 50 mm, 100 mm) |
|
|
Standby die (1.6 or 2.2 mm thick, Ø 100 mm) |
|
|
Tool holder for additional die |
|
|
Adjustment of the construction to special belt lengths on request |
|
|
Adjustment of the construction to special belt widths on request |
|
|
Length: ca. 3,500 mm |
|
|
Width: ca. 1,850 mm |
|
|
Height: ca. 1,250 mm |
Power supply: 400 Volt, 3 Phases, 50 Hz, 16 Ampere
Compressed air: 6 bar
Complete view on WSM 101